Machine In Use; Machine Usage Advice - Numatic TTB6055/100 Bedienungsanleitung

Machine usage advice

Fig.25
Fig.26
Notes:
........................................................................
........................................................................
........................................................................
........................................................................
........................................................................
........................................................................
........................................................................
........................................................................
........................................................................
........................................................................

Machine in use

To operate, turn the master control on/off key to the 'On' position,
select water flow rate, lower the floor-tool press the start / stop
trigger.
Vacuum pick-up, water-flow and chemical-dose will turn on
automatically and the machine will move forward.
The clean water / chemical mix is dispersed evenly via the
'THRU- FEED' scrubbing brushes.
The waste water is then retrieved by the suction floor-tool.
Overlap each scrubbing path by 10cm to ensure an even clean.
Do not operate the machine on inclines that exceed (2%), when
full.
NOTE: Care must be taken to reduce speed when
cornering or when manoeuvring around obstacles.
On heavily soiled floors use a 'double scrub' technique (Fig. 25).
First pre-scrub the floor with the floor-tool in the raised position,
allow the chemical time to work then scrub the area a second
time with the floor-tool lowered.
If streaking occurs wipe floor-tool blades clean (see Fig.26).
42