Filling The Clean Water Tank; Fill-Level Indicator - Numatic TTB6055/100 Bedienungsanleitung

Filling the clean water tank

The TTB 6055 is equipped with a large capacity clean-water tank allowing, for large areas to be covered in a
single fill.
To fill the clean-water tank, extend the hose located to the rear of the machine in the centre of the removable filler cap,
see (Fig.10). Pull out hose, (Fig.11). Open the stopper (Fig.12) and place hose under water tap, or use a hose to
commence filling, (Fig.13).
Or the tank can be filled by unscrewing the filler cap and using a bucket or similar container (Fig.14).
Note: Great care must be taken to ensure that contaminants (leaves, hair, dirt, etc.) are not allowed to enter the
clean-water tank during the filling process. If using a bucket or similar, ensure it is always clean and free from debris.
Fig.15
Machine Set Up
Fig. 10
Fig.12

Fill-level indicator

The water level in the
clean water tank can
be measured using the
scale on the left rear
side of the machine
(Fig.15).
The clean water
bottom tank holds 60
litres.
Fig.11
Fig.13
32
Fig.14