Fitting The Floor-Tool; Machine Set Up; Fitting The Brush - Numatic TTB6055/100 Bedienungsanleitung

!

Fitting the floor-tool

Lower the floor-tool arm by moving the release lever to the lower position (Fig. 4).
Push floor-tool onto the holder and secure with the easy-fit securing pin (Fig.5).
Push waste collection pipe onto the floor-tool; ensure a tight fit (Fig.6).
Note: Raise floor-tool again before moving the machine to the cleaning area (Fig.7).

Fitting the brush

550mm Brush or a 500 Pad on the TTB 6055.
Featuring the Nulock brush system.
The brush is simply pushed and twisted to lock, making fitting and removal a simple process.
Slide the brush / pad under the brush deck (Fig.8).
Fit the brush / pad onto the Nulock drive chuck, twist to lock the brush / pad in place (Fig.9).
Safety gloves are recommended for the changing of used brushes.

Machine Set Up

ALWAYS ENSURE THAT THE MACHINE IS SWITCHED OFF
BEFORE MAKING ANY ADJUSTMENTS
Fig.4
Fig.8
!
Fig.5
30
!
Fig.6
Fig.7
Fig.9