Kondensatormikrofon mit
nieren-charakterisik (9 Seiten)
Inhaltszusammenfassung für RODE Microphones NT1-A
Seite 1
Manual de usuario - producto 1: RØDE NT1 Micrófono de condensador cardioide de diafragma grande con montaje de choque y filtro pop para producción musical, grabación de voz, transmisión y podcasting Manual de usuario - producto 2: Audio-Technica M50x Auriculares de estudio profesionales para grabación de estudio, creadores, DJ, juegos, podasts y escucha diaria...
Seite 2
NT1-A Instruction Manual www.rodemic.com ( EMC, LVD )
Seite 3
NT1-A studio condenser microphone. We’re proud to say that the NT1-A has become an industry standard - providing the warmth, extended dynamic range, clarity and high SPL capability usually only featured by some of the most expensive microphones.
Seite 4
Specifi cations Acoustic Externally polarised 25mm (1”) Principle: condenser Active JFET impedance converter with Electronics: bipolar output buffer Directional Cardioid Pattern: (see graph) Frequency 20Hz ~ 20,000Hz Range: (see graph) Output 100Ω Impedence: Sensitivity: -31.9dB re 1V/Pa @ 1kHz (25mV/Pa @ 94dB SPL) ±2dB @ 1kHz Equivalent Noise: 5dBA SPL (per IEC651)
• Connect all cables before applying power to the microphone and never remove the microphone cable while the power is connected. • The NT1-A requires P48 volts or P24 volts phantom power. • If the mixer or preamp does not contain this phantom power requirement, then an external phantom power supply is needed.
Microphone Placement • The gold dot on the face of the NT1-A indicates the front of the microphone, and the pick-up area of the cardioid pattern. Please be sure to have the side with the dot facing the sound source you wish to record.
Seite 8
Recording vocals • We strongly recommend using the suppled popshield attachment for all vocal recording. This aids in minimising plosive sounds (hard ‘P’, ‘B’, ‘T’ and ‘K’ sounds) that produce a sudden jet of air which can cause the capsule to overload and produce a ‘popping’...
Seite 9
Recording electric guitar/bass • To mic up a guitar or bass amplifi er (as opposed to direct input of that instrument) a microphone may be placed close to the loudspeaker of the amplifi er, directed slightly to the side (off-axis) of the speaker. •...
Seite 10
(like the NT5 or NT55) close to the guitar, with a large capsule microphone like the NT1-A at a distance of around a metre. The individually captured sounds recorded by each microphone can then be mixed as desired.
Seite 11
Recording drums • There are various ways to record drum kits. Single mics ‘overhead’, multiple mics (X/Y or spaced pair) or multiple mics close to individual drums and cymbals (‘close miking’). • To record a kit using a single microphone we suggest that you begin by placing the mic above the direct centre of the kit at the same height as the kit is wide (see below), with the front of the...
Seite 12
Storage • After use the NT1-A should be removed from its shock mount, wiped with a dry, soft cloth and placed in the supplied protective sleeve/dust cover. • Alternatively if the mic is being used regularly, we strongly suggest you cover the mic with the supplied protective sleeve/dust cover.
Seite 13
Warranty microphones are warranted for one year from date of purchase. You can extend that to a full ten years if you register online at www.rodemic.com. The warranty covers parts and labour that may be required to repair the microphone during the warranty period.
Seite 14
한국어 繁體中文 日本語 Français Italiano Português 안전 주의사항 安全上的注意事項 本製品は安全性に充分な配慮をして設計していますが、 Consignes de sécurité Precauzioni di sicurezza Precauções de segurança • 운전 중에 제품을 사용할 경우 휴대폰 및 헤드폰 사용에 • • 若在駕駛時使用本產品 , 請遵循相關法律規定 。 使いかたを誤ると事故が起こることがあります。 事故を未 • Respectez les lois en vigueur concernant l’utilisation de téléphones •...
Seite 15
한국어 繁體中文 Français Italiano Português ■ 각 부품의 이름 및 연결 예 ■ 各部位名稱和連接範例 ■ Nom de chaque pièce et exemples ■ Nome di ciascun elemento ed ■ Nome de cada parte e exemplo de de connexion esempi di collegamento conexão 이...