Ronix RP-U161 Bedienungsanleitung Seite 23

Symptom
Machine refuses to
start
Fluctuating pressure
Machine stop
Fuse blows
Machine pulsating
Machin often starts
and stops by itself
Machine starts, but
no water comes out
Cause
Machine not plugged in
defective socket fuse
has blown defective
extension cord
Pump sucking air valves
dirty worn out or stuck
pump seals worn out.
Fuse has blown
incorrect mains voltage
Thermal sensor
activated nozzle partially
blocked
Fuse to small
Air in inlet hose
Inadequate supply of
mains water Nozzle
partially blocked Water
filter blocked hose
kinked
Pump/spray gun is
leaking center.
Pump/hoses or
accessory frozen no
water supply water filter
blocked
Nozzle blocked
Recommended Action
Plug in machine try another
socket replace fuse. switch off
other machines.
Try without the extension cord.
Check that hoses an the
connections are airtight.
Clean and replace or refer to
local distributor
Clean and replace or refer to
local distributor
Replace fuse. switch off other
machines.
Check that the mains voltage
corresponds to specification on
the model tag.
Leave the washer for 5 minutes
to cool down. clean the nozzle
Change to an installation higher
than the amp.
Allow machine to run with open
trigger until regular working
pressure resumes.
Check that the water supply
corresponds to specifications
required
NB! Avoid using long, thin hoses
(min.1/2")
Clean the nozzle
Clean the filter
Straighten out hose
Contact your nearest service
Wait for pump/hoses or
accessory to thaw.
Connect inlet water.
Clean the filter
Clean the nozzle
21
User Manual