Worx WX445 Bedienungsanleitung Seite 12

1. Locate the plastic motor brush access caps on
either the front or back of the motor housing.
2. Remove the threaded access cap using a flat
head screwdriver and turn in a counter-clockwise
rotation to loosen. Do not apply excessive force
as this may damage the access plug.
3. Remove the old motor brush.
4. Insert the new motor brush making sure that it is
completing inserted into the brush holder.
5. Replace the access cap with the flat-head
screwdriver turning clockwise to tighten.
WORKING HINTS FOR YOUR
CIRCULAR SAW
If your power tool becomes too hot, please run your
circular saw no load for 2-3 minutes to cool the
motor. Avoid prolonged usage at very low speeds.
Protect saw blades against impact and shock.
Excessive feed significantly reduces the performance
capability of the machine and reduces the service life
of the saw blade. Sawing performance and cutting
quality depend essentially on the condition and the
tooth form of the saw blade. Therefore, use only
sharp saw blades that are suited for the material to
be worked.
MAINTENANCE
Remove the plug from the socket before
12
carrying out any adjustment, servicing or
maintenance.
Your tool requires no additional lubrication or
maintenance. There are no user serviceable parts
in your tool. Never use water or chemical cleaners
to clean your tool. Wipe clean with a dry cloth.
Always store your tool in a dry place. Keep the motor
ventilation slots clean. Occasionally you may see
sparks through the ventilation slots. This is normal
and will not damage your power tool.
If the supply cord is damaged, it must be replaced
by the manufacturer, its service agent or similarly
qualified persons in order to avoid a hazard.
ENVIRONMENTAL
PROTECTION
Waste electrical products should not be
disposed of with household waste. Please
recycle where facilities exist. Check with your
local authorities or retailer for recycling
advice.
Circular saw with laser
PLUG REPLACEMENT
(ONLY FOR REWIRABLE
PLUG OF UK & IRELAND)
If you need to replace the fitted plug then follow the
instructions below.
IMPORTANT
The wires in the mains lead are colored in accordance
with the following code:
BLUE =NEUTRAL BROWN =LIVE
As the colors of the wires in the mains lead of this
appliance may not correspond with the colored markings
identifying the terminals in your plug, proceed as follows.
The wire which is colored blue must be connected to
the terminal which is marked with N. The wire which is
colored brown must be connected to the terminal which
is marked with L.
WARNING!Never connect live or neutral
wires to the earth terminal of the plug. Only fit
an approved 13ABS1363/A plug and the correct
rated fuse.
NOTE: If a moulded plug is fitted and has to be removed
take great care in disposing of the plug and severed cable,
it must be destroyed to prevent engaging into a socket.
Connect
Blue to N
(neutral)
Outer sleeve
firmly clamped
13 Amp fuse approved
to BS1362
Brown L (live)
Cable grip
EN