Worx WX445 Bedienungsanleitung Seite 10

TECHNICAL DATA
Type WX445 WX445.1( 4- designation of
machinery, representative of Sa
Rated voltage
Rated power
Rated no load speed
Max. cutting
capacity
Bevel capacity
Blade size
Protection class
Weight
NOISE INFORMATION
A weighted sound pressure L
K
pA
10 A weighted sound power L
K
wA
Wear ear protection.
VIBRATION INFORMATION
Vibration total values (triax vector sum) determined
according to EN 62841:
Vibration emission
value
The declared vibration total value and the declared
noise emission value have been measured in accor-
dance with a standard test method and may be used
for comparing one tool with another.
The declared vibration total value and the declared
noise emission value may also be used in a prelimi-
nary assessment of exposure.
WARNING: The vibration and noise emissions
during actual use of the power tool can differ
from the declared value depending on the
ways in which the tool is used especially what kind of
workpiece is processed dependant on the following
examples and other variations on how the tool is
used:
Circular saw with laser
WX445 WX445.1
220-240V ~50/60Hz
1600W
5000/min
90° 66mm 64mm
45° 47mm 45mm
0-51°
190mm 185mm
/II
4.3kg
L : 82dB(A)
pA pA
L : 93dB(A)
wA wA
Cutting wood: a = 4.36m/s
h,W
Uncertainty K=1.5m/s
2
How the tool is used and the materials being cut or
drilled.
The tool being in good condition and well
maintained.
The use of the correct accessory for the tool and
ensuring it is sharp and in good condition.
The tightness of the grip on the handles and if any
anti vibration and noise accessories are used.
And the tool is being used as intended by its design
and these instructions.
This tool may cause hand-arm vibration
syndrome if its use is not adequately managed.
WARNING: To be accurate, an estimation of
exposure level in the actual conditions of use
should also take account of all parts of the
operating cycle such as the times when the tool is
switched off and when it is running idle but not
actually doing the job. This may significantly reduce
the exposure level over the total working period.
Helping to minimise your vibration and noise
exposure risk.
Always use sharp chisels, drills and blades.
Maintain this tool in accordance with these
instructions and keep well lubricated (where
appropriate).
If the tool is to be used regularly then invest in anti
vibration and noise accessories.
Plan your work schedule to spread any high vibration
3dB(A)
tool use across a number of days.
ACCESSORIES
3dB(A)
Vacuum adaptor
Parallel guide
Hex key
Blade: 190mmx30mmx24T (only for WX445) 1
Blade: 185mmx16mmx24T (only for WX445.1) 2
We recommend that you purchase your accessories
listed in the above list from the same store that sold
you the tool. Refer to the accessory packaging for
2
further details. Store personnel can assist you and
offer advice.
OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.
INTENDED USE:
The machine is intended for lengthways and
crossways cutting of wood with straight cutting lines
as well as bevel angles to 51° while resting firmly on
the work piece.
1. DEPTH OF CUT ADJUSTMENT (See Fig. A)
Lift the depth of cut lock lever and raise the saw body
away from the base plate. Set the depth of cut with
the scale and push the lever down to lock. Always
1
1
1
EN