Rectifying Faults; Maintenance And Cleaning; Maintenance Of The Alarm System; Cleaning - Dexaplan BA 611 Bedienungsanleitung

Rectifying faults / Maintenance and cleaning

Rectifying faults

Fault Cause
Motion detector Pets, air move-
detects motion ments, direct
without apparent light, etc.
reason.
The range of the Ambient temper-
motion detector ature is too high
is not adequate. (20°C is optimal).
Device is mounted
too low or too
high.
The LED There is no
flashes regularly. backup battery
connected or the
connected back-
up battery is too
weak.
The called The telephone
number does number was in-
not receive a correctly or not
call on alarm. entered.
36 GB/MT
Remedy Fault
Change the
position of the
motion detector.
Use a masking
sticker to
restrict a par-
ticular part of
the detection
angle / range.
Change the
position of the The device
motion detector. does not react
to the pass-
Change the word.
mounting
height or the
inclination of
the motion
detector.
Connect a new
backup battery.
Enter the tele-
phone number
again.
Cause Remedy
Dialling function Set the dialling
is switched off function on.
( appears on ( does not
the LC display. appear on the
LC display.
The telephone Check the
line is faulty. telephone line
with an
analogue tele-
phone.
You have not Press the OK
y
yet given a key to arm/
command after disarm the
password entry. device.
Press the PROG
r
key to enter
settings mode.
The password Enter the cor-
entered is rect password.
wrong. If you have
forgotten the
password, set
the device back
to the factory
settings as de-
scribed in the
section "Chang-
ing the pass-
word".
Fault Cause
Your settings The settings
were not were not con-
stored. firmed.
There are other
faults
Should you have further questions or problems please
consult www.dexaplan.com where you can find informa-
tion on problem handling.

Maintenance and cleaning

Maintenance of the alarm system

You should regularly check the device to see that it is
safe and working properly.

Cleaning

Before you clean the device, pull the mains adapter out
of the mains socket. Use a dry or slightly moist cloth for
cleaning the device. Never immerse the device in water.
Do not use solvents to clean the device.
Remedy
Press the OK
y
key to
confirm the
settings.
Carry out a re-
set (see section
"Making the
settings" item
"Reset").