Publishing Notes - Hauff-Technik Bd68 Montageanleitung

Site power supply entry
BD68/90
2 ENSite pow er supply entr y
Table of Contents
1

Publishing Notes ........................................................ 7

2 Explanation of Symbols ............................................. 7
3 Tools and aids required ............................................. 7
4 Description ................................................................ 7
5 Installation................................................................. 7
1 Publishing Notes
Copyright © 2023 by
Hauff-Technik GmbH & Co. KG
Department: Technical Editing
Robert-Bosch-Straße 9
89568 Hermaringen, GERMANY
Tel. +49 7322 1333-0
Fax +49 7322 1333-999
E-mail office@hauff-technik.de
Internet www.hauff-technik.de
Reproduction of this Installation instructions – even in
extracts – in the form of reprint, photocopy, on electronic
data media or using any other method requires our writ-
ten consent.
All rights reserved.
Subject to technical alterations at any time and without
prior announcement.
These installation instructions form part of the product.
Printed in the Federal Republic of Germany.
2 Explanation of Symbols
1 Work stages
► Effect/result of a work step
Reference numerals in drawings

3 Tools and aids required
For the correct installation of the Site power supply
entry BD68/90, the following tools and aids are required in
addition to the usual standard tools:
Tools:
1 Flexible socket wrench SLS 6G
Aids:
Cable cleaner KRMTX (Hauff)
Cleaning cloth
4 Description
Description: Site power supply entry BD90
Art. Nr.: 5090033015 Rev.: 03/2023-07-20
3
2
1
1 Cable
2 Mounting frame
3 Intermediate pipe Ø
Type Frame dimension
Ø (mm)
BD68 120
BD90 120
5 Installation
For multiple arrangement: centre distance ≥170
mm.
1 Nail the Site power supply entry to the wooden form-
work using the nail holes (in mounting frame) provi-
ded for this purpose. If the formwork is made of
steel, then attach the wall insert to the reinforcement
with wire.
Next, close the shuttering.
2 Set in concrete.
During the process of setting in concrete, make
sure that packing is carried out in layers in the vi-
cinity of the construction wall entry. Cavities must
be avoided.
EN
= 110 mm
a
Inner diameter
(mm)
68
90
7