Silvercrest SHTD 2200 E2 Bedienungs- Und Sicherheitshinweise Seite 19

No action is needed from users to
shift the product between 50 and
60 Hz . The product adapts itself
for both 50 and 60 Hz .
Cleaning and storage
Store the product in a cool, dry
place, protected from moisture
and out of the reach of children .
˜ Before first use
Remove the packaging . Check if all parts are
complete .
NOTE: The product may give off some odour
during first use . These are production or transport
residue that will quickly subside .
˜ Operation
˜ Drying hair
(Fig . A)
Connect the power plug 6 to a suitable electrical
outlet .
Select the desired air flow and heat levels:
/ / 7
(Switch position)
18 GB/IE
Air flow
Product off
Product on: gentle air flow
Product on: strong air flow
/ / 8
(Switch position)
After use: Select
Disconnect the power plug 6 from the electrical
outlet .
˜ Ionization mode
(Fig . B)
/ 4
(Switch position)
NOTE: Remove the concentrator nozzle 11
before using the ionization mode . This optimises
the ionization performance . Use strong air flow
( 7 ) and high heat level (
mode to dry hair quickly .
˜ Styling hair
Using the concentrator nozzle
Put the concentrator nozzle 11 on the air outlet
10 .
Rotate the concentrator nozzle 11 to change the
position .
Switch on the product . Use the concentrator
nozzle 11 to direct the air flow onto a specific
section of the hair .
NOTE: We recommended to use gentle air flow
( 7 ) and low heat level (
hair .
m
CAUTION! Do not remove the concentrator
nozzle 11 when it is still hot .
Heat
No heat
Low heat
High heat
7 to switch off the product .
Ionization LED 1
Ionization off
Ionization on
8 ) in ionization
8 ) when styling
Off
On