Huffy Disney Ride On Bedienungsanleitung Seite 5

STEP - Front Wheels:
1
1. Remove any axle protection caps from axles.
(Ensure washer is on both front axles
2. Attach both Front wheels
wheels fully onto the Axle while pushing
in the center hub-cap button
wheels SNAPS into place.
3. Gently pull out on wheel to make sure it
does not come loose.
4. Position Hubcap
D
slots in wheels and SNAP evenly into place.
G
F
STEP - Rear wheel:
2
1. Remove any axle protection caps from axles.
2. With axle in place, make sure two washers
A
3. Put right rear wheel
4. Install drive wheel
5. Push drive wheel onto axle until it SNAPS into place.
6. Gently pull both wheels to make sure they do not come loose.
7. Position both hubcaps
NOTE:
Wheel release button
Assembly
A
B by fitting
C until the
so tabs line up with
D
E
onto axle and push until it SNAPS into place.
C
onto axle so that gears fit inside motor
D
so tabs line up with slots in wheel and snap into place.
F
.
G
D
)
C
A
are positioned as shown on right side.
B
E
A
B
B
.
EN
1
2
C
5