Huffy Disney Ride On Bedienungsanleitung Seite 11

FOLLOW THESE STEPS IF THE BATTERY NEEDS TO BE REPLACED:
NOTE:
Batteries are installed, mounted and wired differently depending on model. Make a simple
drawing on paper (or take pictures) how your battery is installed and how Red and Black wires are
connected.
NOTE:
Remove seat screws and seat (varies depending on model).
1. Remove any clamps and Battery Covers.
2. Disconnect wires.
3. Carefully lift out the Battery.
• Depending on the condition of the battery (i.e.: leakage) you may want to wear protective
rubber gloves before removal.
• Do not lift the battery by its connectors or cables.
4. Place the dead batteries in a plastic bag.
5. Install replacement battery(s) in same position and orientation as originals.
6. Re-connect all wires in original positions.
7. Re-install Battery Covers and hold-down clamps and screws.
WARNING:
Ensure no wires are pinched or bound up.
PARTS:
1. Battery Connector
2. Red and Black Terminals
3. Clamp and Screws
4. Thermal Fuse
Drive Battery Replacement
1
3
EN
2
4
11