Synchronizing Receiver and Transmitter
The transmitter is adjusted to the receiver's channel via infrared signal.
1
Point the transmitter's infrared sensor towards the receiver's infrared
interface. Hold the transmitter at the height of the receiver and keep a
line-of-sight. The distance must not exceed 1.5 m.
2
Shortly press the AFS SET button on the receiver to transfer the
channel information to the transmitter. The display will indicate
during the IR transmission. When the receiver section and the
transmitter have been set to the same transmission channel, the RF
bargraph on the receiver's display will indicate that a radio signal is
being received. The more segments by the bargraph are displayed,
the better is the reception.
14