Omnitronic UHF-502 Bedienungsanleitung Seite 13

5
SETUP
Inserting Batteries
1
For operation, the transmitter requires two 1.5 V AA batteries. Fold up
the cover of the battery compartment and insert two batteries as
indicated in the compartment.
2
If the transmitter is not used for a longer period, please remove the
batteries to prevent damage in case of battery leakage.
Fastening the pocket transmitter and connecting the microphone
1
Attach the transmitter with the belt clip to your clothing or strap on
your instrument.
2
Connect the included microphone to the microphone input and attach
it to your clothing.
Switching on/off
1
Set the power switch to ON to switch on the transmitter. The battery
indicator shortly lights up. If the indicator lights up continuously during
operation, the inserted batteries are going flat and have to be
replaced. The capacity of the batteries is indicated on the display:
2
To switch off the transmitter, set the sliding switch to OFF.
Adjusting Transmission Power and Gain
1
Use the POWER selector to adjust the transmission power: position HI
= high power for a long range, yet reduced battery life, position LO =
reduced range for a long battery life.
2
The volume level of the transmitter can be adjusted by changing the
sensitivity with the GAIN control. Use a small screwdriver for this.
Reduce the sensitivity if the volume of the transmitter signal is too high
and thus distorted. Increase the sensitivity if the volume is too low and
a poor S/N ratio results.
13