Werbung
Verfügbare Sprachen
Verfügbare Sprachen
HANGER (Fig. C)
EN
The hanger is designed for hanging the power plug. It
can be placed in two positions. The lower position is for
hanging the power plug (Fig. A). The higher position is for
convenient storage.
C-1
Hanger
WALL-MOUNT HOLES (Fig. D)
The charger has four hanging holes for convenient
storage. Install four screws on the wall 305 mm apart
horizontally and 152.4 mm apart vertically to hang
the charger. Use screws sufficiently strong to hold the
charger.
D-1
Wall-mount Hole
WINDING GROOVE (Fig. E)
When the charger is hung on the wall, there will be a
groove towards the back of the charger. The groove can
be used as a winding groove. Wind the power cord in the
winding groove if it is too long to use conveniently.
E-1
Winding Groove
MAINTENANCE
WARNING:
To avoid serious personal injury, always
disconnect the battery pack from the charger when
cleaning or performing any maintenance.
WARNING:
When servicing, use only identical EGO
replacement parts. Use of any other parts may create a
hazard or cause product damage.
WARNING: It is not recommended to use
compressed dry air as a cleaning method of the
charger. If cleaning with compressed air is the only
method to apply, always wear safety goggles or safety
glasses with side shields when cleaning the charger. If
the operation is dusty, also wear a dust mask.
WARNING: If the power cord is damaged, it must
be replaced by the manufacturer, its service agent or
similarly qualified persons in order to avoid a hazard.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use.
Use clean clothes to remove dirt, dust, oil, grease, etc.
6
56 VOLT CHARGER — CHV1600E
WARNING:
Do not at any time let brake fluids,
gasoline, petroleum-based products, penetrating oils,
etc. to come in contact with plastic parts. Chemicals can
damage, weaken or destroy plastic which may result in
serious personal injury.
WARNING:
When servicing, use only identical EGO
replacement parts. Use of any other parts may create a
hazard or cause product damage. To ensure safety and
reliability, all repairs should be performed by a qualified
service technician at an EGO Service Center.
When not in use, store the machine in door.
Protecting the environment
Do not dispose of electrical appliances as
unsorted municipal waste, use separate
collection facilities.
Contact your local government for
information regarding the collection
systems available.
If electrical appliances are disposed of in
landfills or dumps, hazardous substances
can leak into the groundwater and get into
the food chain, damaging your health and
well-being.
Werbung
