Safety Warnings - Astralpool LUMIPLUS ESSENTIAL MINI Einbau- Und Betriebsanleitung

6. SAFETY WARNINGS:

• People in charge of assembly should be suitably qualified for this type of work.
• Avoid making contact with the electric voltage.
• Comply with the current standards regarding accident prevention.
• In this regard, the IEC 364-7-702 standards must be observed: WIRING IN BUILDINGS SPECIAL WIRING SWIMMING POOLS
• All maintenance operations should be performed with the projector disconnected from the Mains.
• The luminaire should be fitted in such a way that it is not possible to stare at it from closer than 2m.
• The power cable on this luminaire cannot be replaced; if it becomes damaged, the luminaire must be destroyed.
7. ASSEMBLY AND FUNCTIONING WARNINGS:
• It is not recommended the use of sealing putty in this product and, anyway, you should use only products specifically conceived
to work with ABS, all those products of universal use remain excluded.
• The projector is designed TO OPERATE ONLY WITH A SAFETY TRANSFORMER.
• The manufacturer is not responsible in any circumstances for assembly, installation or start-up of any electric components which
have been inserted or handled at locations other than its own premises.
• It is responsibility of the installer to ensure that no water gets inside the projector by means of the cables.
• This projector is resistant to pool treatments described below, always that the concentration values do not exceed the following
levels:
Chlorine
Bromine
Salt electrolysis (Na Cl)
Attention : Please note that the Ph of pool water always must be between 7.2 and 7.6.
TYPE OF TREATMENT CONCENTRATION IN WATER
2 mg/l
5 mg/l
-
3