Back Panel Connections - T+A Elektroakustik Pa 2000 R Betriebsanleitung

IN 1 ... IN 3
IN 4 ... IN 6
GND
Ground terminal
PRE OUT

54

Back panel connections

Universal pre-amplifier line inputs for connecting any stereo audio or TV equip-
ment fitted with symmetrical XLR outputs.

In the System Configuration menu it is possible to set input IN 3 (SRND) to
separate volume control for use with surround decoders. For more information
please see the chapter entitled 'Surround operation with the PA 2000 R'.
Universal pre-amplifier line inputs for connecting any stereo audio or TV equip-
ment fitted with asymmetrical RCA (Cinch) outputs.

In the System Configuration menu it is possible to set input IN 5 to separate
volume control for use with surround decoders. For more information please
see the chapter entitled 'Surround operation with the PA 2000 R'.

Input IN 4 can be upgraded to form an input for an analogue turntable by fitting a
Phono MM or Phono MC module (optional accessories).
The ground lead from an analogue record player is connected here in order to
avoid hum.
RCA (Cinch) pre-amplifier output for connecting external output stages or active
loudspeakers.
One pair of loudspeakers can be connected to the amplifier (SPEAKER  R
and SPEAKER  L). The impedance of each speaker must not be lower than
4  (DIN rating).

Caution!
The load capacity of the loudspeakers connected to the device must be
appropriate to the amplifier. The speaker impedance must be at least 4 Ohm
(DIN rating). Always connect your loudspeakers using ready-made,
purpose-designed speaker cables terminating in approved connectors. The
speaker cables and connectors must be insulated in accordance with
regulations, and the conductors must have a minimum cross-sectional area
of 1.5 mm².Make sure that the terminals are firmly screwed down, and that
no short-circuits are possible.