Party Mode; Demo Mode; Deep Standby Mode; Factory Reset - Harman Jbl Rallybar S Bedienungsanleitung

1. Press and buttons simultaneously 2 seconds to enter or
exit Broadcast mode.
2. Repeat Step 1 for all additional soundbars.
3. When in broadcast mode the backlight of
BROADCASTING
constant blue status.
EN
1
Notes:
- Broadcast Mode is compatible with AUX-IN, USB-Disk and
Bluetooth input sources.
- Both audio and the RGB light will synchronize on broadcast mode
- Local source (Bluetooth/AUX-IN&USB) can break-in
broadcasting mode: Secondary soundbar receives music from
other soundbar only when local source not playing on Secondary
soundbar
- In Broadcast mode, only the Primary soundbar will synchronize
the volume or RGB light change to other soundbar, while the
Secondary/third /forth.... soundbar will not synchronize the
volume change to other soundbar.
- RALLYBAR can connect with RALLYBAR, RALLYBAR S and
RALLYBAR XL in Broadcast mode
- Multiple soundbars Broadcast mode connect scenarios example
below:
A
soundbar
Scenario 1 playing
music
when enter
broadcast
mode
Scenario 2 playing
music
when enter
broadcast
mode
Scenario 3 playing
music
when enter
broadcast
mode
button will be
B C Result
soundbar soundbar
Not playing / A is primary, B
music is Secondary
when enter
broadcast
mode
playing / Both A and B
music are primary,
when enter cannot
broadcast connect to
mode each other;
need one
of the 2
soundbars
stopping
music to
become
secondary.
playing Not Both A and B
music playing are primary, C
when enter music will connect A
broadcast when enter or B randomly
mode broadcast to become
mode the secondary

7.6 Party Mode

PARTY MODE
One soundbar have simultaneous connection of up to two
Bluetooth devices.
®
Notes:
- When turn off the soundbar speaker, it will only connect the
device with the latest action automatically, user need manually
connect the second device.
- Maximum 2 devices connect at same time, Last action on one of
the devices will always take the control.
- Third device cannot find soundbar speaker's name when there
are 2 Bluetooth devices are connected.
2

7.7 DEMO Mode

Button Press
To enter or exit from DEMO MODE, press and hold
"Bluetooth"&"play/pause" button at same time 5 seconds
NOTES:
- Only AUX audio can work, USB & Bluetooth is disabled
- Long Press light button will switch to next pattern. short press
for MAP lights turn on/off/50%
Every 30 seconds, auto switch to next light pattern in following
sequences:
Rock -> Flow -> Cross -> Ripple -> Flash -> Static1 -> Static2 -> Mix
if no action for 1 hours, device will auto switch to default pattern Rock

7.8 DEEP STANDBY MODE

The product will enter into Deep standby mode
• If there is no Bluetooth connection and there is no any action
over 15 minutes.
• If there is Bluetooth connection and there is no any action over
1 hour.
Note:
- Power button's backlight is on white and slow flash status and rest
buttons' backlights are off, if product is on Deep standby mode
- The MAP light can be turned on or off in Deep standby mode,
while if there is no any button press action over 15 minutes, MAP
lights will shut-off automatically.
- Press the power button, the product will exist from deep standby
mode

7.9 FACTORY RESET

To restore the factory settings, Press
simultaneously 10 seconds.
8
Behaviors
To enter or exit DEMO mode
5S
and buttons