T+A G 2000 R Betriebsanleitung Seite 34


Loudspeaker and signal
cables
Mains cables and mains
filters
Care of the unit
Storing the unit
34
If you encounter problems when setting up and using the integrated amplifier
for the first time please remember that the cause is often simple, and equally
simple to eliminate. Please refer to the section of these instructions entitled
'Trouble shooting'.
Loudspeaker cables and signal cables (inter-connects) have a significant
influence on the overall reproduction quality of your sound system, and their
importance should not be under-estimated. For this reason  recommends
the use of high-quality cables and connectors.
Our accessory range includes a series of excellent cables and connectors
whose properties are carefully matched to our speakers and electronic units,
and which harmonise outstandingly well with them.
For difficult and cramped situations the  range also includes special-length
cables and special-purpose connectors (e. g. right-angled versions) which can
be used to solve almost any problem concerning connections and system
location.
The mains power supply provides the energy which your sound system
equipment needs, but it also tends to carry interference from remote devices
such as radio and computer systems.
Our accessory range includes the ready-to-use 'POWER THREE' mains cable
with integrated shell-type filters and the 'POWER BAR' mains filter distribution
board which prevent electro-magnetic interference from entering your Hi-Fi
system. The reproduction quality of our systems can often be further improved
by using these items.
If you have any questions regarding cabling please refer to your specialist 
dealer who will gladly give you comprehensive expert advice without obligation.
We would also be happy to send you our comprehensive information pack on
this subject.
Disconnect the mains plug at the wall socket before cleaning the case.
The surfaces of the case should be wiped clean with a soft, dry cloth only.
Never use solvent-based or abrasive cleaners!
Before switching the unit on again, check that there are no short-circuits at the
connections, and that all cables are plugged in correctly.
If the device has to be stored, place it in its original packaging and store it in a
dry, frost-free location. Storage temperature range 0...40 °C