Troubleshooting - Home Deluxe Coway Bidet Bedienungsanleitung

trouBLesHootiNg

the bidet may operate abnormally due to minor causes not because of a product malfunction but because the
user is unfamiliar with using the product. in such a case, problems can be easily solved even without the help
of the service center by checking the following. if you cannot solve the problem after checking the following
items, please call the service center.
ProBLeM
• Make sure the bidet is plugged in.
The product is not
• Check if there was a power failure.
working.
• Check if the remote control batteries are flat. Replace them if necessary.
• Make sure the water valve is opened.
No water is ejected. • Clean foreign material from the nozzle outlet holes using a toothbrush.
• Make sure the water supply is running.
• Make sure that the water pressure is not too low.
The water pressure is
• Clean foreign material from the nozzle outlet hole using a toothbrush.
weak.
• Remove, clean and then reinstall the filter (refer to p.20)
• Make sure that the seat and water temperature control buttons are set to the 'ON'
• This bidet has a bimetal as one of safety device for water heater. The safety
The seat or the water is
not warm.
• If water is leaking from the T-shaped connector, make sure that the rubber packing
• If water is leaking from the bidet hose connection, make sure that the bidet hose is
Water leaks from areas
• If water is leaking from the filter, check if there is any foreign material between the
other than the nozzles.
• In this case, install the filter completely or reinstall the filter after cleaning it.
• The water that comes out between the nozzles after cleansing is for cleaning the
Water is emitted while
the bidet is not in use. • In some cases, water remaining around the nozzles may drip into the toilet. This is
The bidet does not
work when the buttons • If the seat sensor cannot detect that you are seated because you are too far away,
on the operation part
are pressed.
When bidet power-saving mode is set, you may feel that the seat is relatively cold when taking a
seat. if bidet power-saving mode is cancelled, the last set temperature is maintained.
for cancelling bidet power-saving mode, see page 11.
tips
if the bidet or remote control is flooded, it may cause a malfunction or other problem.
status. Please adjust the setting to the correct temperature by pressing the seat
temperatre button or the water temperature button.
device may cycle 'OFF' if temperature exceeds over normal level. In the event of
the safety device operation, the bidet do not work and show error message until
the appliance cool down and then the bimetal will automatically reset. If the error
message shows up, you can restart the bidet by pressing any button of remote
control.
is inserted into the T-shaped connector, and firmly tighten the nut again.
connected completely.
filter and the product.
Check whether the filter is damaged. If the filter is damaged, call our service
center.
nozzles, and is not a malfunction.
not a malfunction.
functions do not work.
soLutioN
22