Installing The Product - Home Deluxe Coway Bidet Bedienungsanleitung

iNstaLLiNg your Bidet

installing the product

1. turn off the main water supply valve ① and separate the existing water
tank hose ②.
2. connect the rubber packing, t-shaped connector, and water tank hose in
this order to the existing water pipe. Please connect the bidet hose to the
t-shaped connector.
Please ensure that the rubber packing is inserted between the water pipe
and the T-shaped connector.
Firmly tighten the nuts below and on top of the T-shaped connector all the
way to the end in a clockwise direction.
3. Place the fixing slider over the installation plate on the toilet, insert the
fixing bolts, and fasten the nuts so that the installation plate is fixed.
4. align the back of the bidet to the installation plate and push the bidet
backwards while pressing the button to the left of the bidet. (Hold the
bidet with both hands and push it backwards until it clicks into place).
check if the bidet moves to the left or right. if it moves, fasten the fixing
nuts again.
5. connect the bidet hose to the side of the bidet.
make sure that the bidet hose is firmly connected. if the main water supply valve
is opened when the hose is not connected properly, the bidet hose may become
separated and cause water to splash, resulting in injury.
6. open the main water supply valve.
7. connect the power cord to the electrical outlet
caution
17
17
make sure to use a grounded electrical outlet. in the case of a short
circuit, grounding prevents electric shock or injury.
make sure to use a dedicated electrical outlet with grounding
terminals.
if using an extension cord is unavoidable, use one with grounding
terminals for (220-240 V~, 50/60 Hz) or higher.
2
1