Installing The Remote Control Wall Mount - Home Deluxe Coway Bidet Bedienungsanleitung

iNstaLLiNg your Bidet

installing the remote control wall mount

Make sure to install the remote control wall mount on the wall using the supplied screws. failing
to do so may result in the product falling and being damaged.
i f the bathroom has 3 sides in a black or similar color, use the remote control while fixing it to the
wall holder.
tips
failing to do so may result in the product not working properly due to the remote control signal
reception ratio being too low.
1. Place the remote control wall mount over the required position on
the wall and mark the 2 points for the anchors on the wall.
2. drill 2 holes with a depth of approximately 35 mm at the marked points.
use a drill bit with a diameter of ∅ 6.5 mm.
3. insert the anchors into the holes and push them all the way in.
4. remove the protective film from the back of the remote control wall
mount, and attach the mount to the wall aligning the holes with the
anchors in the wall.
5. Place the remote control into the mount as shown by the figure.
18