Rennsteig HC 20 Betriebsanleitung Seite 26

Operating Manual HC 20
Inserting the battery (Figure 3)
Push the battery into the tool as shown until it
locks into place.
Battery status display (Figure 1)
The 4 green LEDs (4) show the battery's charge level. The number of LEDs illuminated indicates
the charge level. If the LED (2) flashes, the battery is discharged and no more movement is
possible.
7.4 HC 20 and battery
Please note!
The crimping device HC20 must be operated by a 12 V lithium-ion rechargeable
battery. The 12 V battery must only be used in the basic devices suitable for this.
Please note!
The batteries are not charged at the factory.
Accordingly: Charge the battery before first using the tool.
Please note!
Specific temperatures apply to charging performance and battery storage.
Accordingly: Ensure you follow the charger's operating instructions!
Behaviour of the crimping tool after prolonged non-use or when the battery is
replaced
Rev.: 06/11/2013
Figure 3
EN
9 / 17