Prosharp BAUER ADVANTEDGE Maschinenhandbuch Seite 13

TRAVELING WITH THE PROSHARP BAUER ADVANTEDGE
• Proceed with a complete cleaning cycle by following the "Cleaning and Emptying the Dust Tray"
section of page 10 of this manual.
• When cleaning is completed, close the front door and ensure the grinding wheel is in the home
position (right side of the machine).
• Switch Power Off.
• Unplug the power supply.
For the highest level of protection and safety, we recommend traveling with the PROSHARP BAUER
carry bag (sold separately).
ALERT:
When setting up the machine after travel, wipe down the clamp and grinding wheel housing
to remove any unwanted steel shavings that may have gathered during transit. This will ensure proper
fit of the grinding wheel when sharpening again.
Machine Warning
Verify grinding wheel
Clamping problems
Check blade height
Maintenance cleaning
Loss of power
Error
TROUBLESHOOTING
Cause and solutions
When there is a difference of hollow between your selected user
preference and the current wheel installed on the machine. Dismiss the
warning or open the door and change the wheel.
Your skate blade is probably not positioned correctly. Make sure your
skate is leveled before clamping. If your skate is clamped correctly
and the machine still detects a problem, make sure there is no object
obstructing the clamp.
Your skate blade is probably too low in height. The machine cannot
sharpen when it reaches the security limit. Make sure your skate is
clamped properly or change your blade.
You need to proceed with the cleaning routine of your machine.
Your machine experienced a loss of power during a sharpening
sequence, resulting in an abrupt stop in the process. Please check your
blade sharpening result and proceed with a new sharpening if needed.
There is a problem with your machine. Try rebooting your machine by
doing a power cycle. If rebooting and all of the above do not help
with troubleshooting, please call customer service.
13