Start Of Operation; Side Handle Installation; Use; Depth Stop Setting - Metabo BHE 20 SP Gebrauchsanleitung

17026895_0308 BHE_Gu incl RU.book Seite 13 Montag, 31. März 2008 8:58 08
Metabo contact mode:
(KHE 26 Contact)
For intelligent drilling in walls with installed electric
or water lines. As soon as the inserted tool makes
contact with conductive, earthed material or live
supply cables, the machine switches off
immediately.
Metabo CODE! System
(KHE 28, KHE 26, BHE 26, KHE Partner Edition)
The Metabo CODE! System is an electronic anti-
theft device with which you can lock your Metabo
machines (if fitted with CODE!) to protect them
from abuse. Once locked, a machine can no longer
operate and therefore cannot be used by a
potential thief.

7 Start of Operation

Wefore plugging in check to see that the
rated mains voltage and mains frequency,
as stated on the rating label, match with your
power supply.
7.1

Side handle installation

Wor safety reasons, always use the side
handle supplied.
Open the clamping ring by turning the side handle
(17) counter-clockwise. Place the side handle onto
the machine's collar. Insert the depth stop (7).
Tighten the side handle in the required angle
depending on the task at hand.

8 Use

8.1

Depth Stop Setting

Loosen the side handle (17). Set depth stop (7) to
the desired drilling depth and retighten the side
handle.
8.2

Switching on/off

To start the machine, press the trigger (14).
The speed can be changed at the trigger.
This machine has an electronic soft start.
For continuous operation the trigger can be locked
with the lock button (13). To stop the machine,
press the trigger again.
If switched on continuously, the machine
continues running if it is jerked out of your
hands. Therefore, always hold the
machine with both hands on the handles, stand
safely, and concentrate on your work.
8.3

Speed preselection (KHE 26 Contact)

Depending on the application, the optimum speed
is preset with the pre-selector wheel (8).
8.4

Operating mode selection

Select the desired operating mode by turning the
control knob (16). To turn, push the stop (15).
twist drilling
hammer drilling
(only with use of hammer drill chuck)
chiselling
(KHE 28, KHE 26 Contact,
KHE 26, KHE 22 SP, KHE 24 SP,
KHE 26 SP, KHE Partner Edition)
(only with use of hammer drill chuck)
In chisel mode the chisel is locked to be twist-proof.
To position the chisel for the particular application,
set the control knob (16) between
.
When a chisel is fitted, only operate
the machine in the chiselling operating
mode.
Avoid levering movements of the machine
when a chisel is fitted.
8.5

Selection of direction of rotation

Do not actuate the rotation selector
switch (12) unless the motor has
completely stopped.
Select direction of rotation:
R = clockwise
L = counter-clockwise
8.6

Drill chuck change

(not KHE 22 SP, KHE 24 SP, KHE 26 SP,
BHE 22, BHE 20 SP)
When changing chucks make sure that
the spindle is clean. Grease spindle lightly
if required.
Removing the chuck:
Turn chuck lock (5) in direction indicated by arrow
against the stop (a) and pull it off the spindle (b).
ENGLISH
ENG
and
13