Herunterladen Inhalt Inhalt Diese Seite drucken

General Failures And Troubleshooting Methods - ISE SY-T1507 Bedienungsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 46
6.1 ERROR CODE AND TROUBLESHOOTING OF ELECTRONIC METER DISPLAY
CODE
FAULT DESCRIPTION
E1
Communication
exception: after power
on, down controland
electronic meter
communication exception.
E2
Indicates that the
voltageon the motor
is not detected by
the controller.
E3
Speed free sensor
signal
E5
Overcurrent protection
E6
Bursting protection
E7
Nosafety lock signal
was detected.
ENGLISH
12.

6. GENERAL FAILURES AND TROUBLESHOOTING METHODS

FAULT TREATMENT
Electronic meter display fault code, buzzer rings 3 times.
POSSIBLE REASON: Electronic control and electronic meter communication is
blocked, check every section of the connection from the electronic meter to the
down control communication line, to ensure that the core is completely inserted.
Check whether the connection line between the electronic watch and the controller
is damaged, and replace the connecting line.
1.-
Check whether the terminal connection on the motor line is firm.
Shutdown to enter the fault state, the electronic watch's buzzer rings 9 times,
2.-
and the fault code is displayed at the same time.
The rest of the area does not display the contents. After the failure state is
maintained for about 10 seconds, it will be in standby mode and restart.
Possible Cause: No speed sensor signal was detected for 3 seconds, check if
the sensor plug was not plugged in or damaged, plug it in or replace the
sensor.
Shutdown to enter the fault state, the electronic watch's buzzer rings 9 times ,
3.-
and the fault code is displayed at the same time, the rest.The rest of the area
does not display the contents. If it is normal after shutting down, it can enter
standby mode and start normally.
POSSIBLE REASON: check whether the motor line is connected and re connect
the motor line. Check whether the controller has peculiar smell and replace the
controller.
Shutdown to enter the fault state, the electronic watch's buzzer rings 9 times, and
the fault code is displayed at the same time.
The rest of the area does not display the contents. After the failure state is
maintained for about 10 seconds, it will be in standby mode and restart.
POSSIBLE REASON : Exceeding the rated load leads to excessive current. system
self-protection, or a certain part of the running machine is stuck, resulting in motor
can not run, overload, excessive current, the system self-protection; adjust the
running machine and reboot operation , and check whether the motor has
overcurrent sound or burning smell when running, change the motor , or check
whether the controller has smells of burning, replace the controller, or check
whether the power supply voltage specifications are not in conformity with or
lower, and re-test with the correct voltage specifications.
POSSIBLE REASON: check whether the power supply voltage is below 50% of
the normal voltage, please use the correct voltage specifications to re-test; check
whether there is peculiar smell in the controller, replace the controller; check
whether the motor line is connected properly, reconnect the motor line.
Magnetron damage, whether magnetron installation position is correct, whether
the magnet is put away.

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

S102-5

Inhaltsverzeichnis