Lubricating Oil - ISE SY-T1507 Bedienungsanleitung

B. RUNNING BELT CENTRING ADJUSTMENT
When you use the running machine, the pressure on the running belt is unbalanced because the two feet
exert different forces during running, which leads to the deviation of the running belt from the center. This
deviation is normal. When no one is running on the operating running belt, it will return to the center. If
the running belt can't get back to the center, you need to adjust the running belt back to the center
C. RUN THE RUNNING MACHINE WITH NO LOAD AND SPEED TO 6KM/H.
OBSERVE THE DISTANCE FROM RUNNING TO THE LEFT AND RIGHT STRAKE.
If left deviation, use the hexagon spanner, turn the left screw 1/4 turns clockwise.
If right deviation, use the hexagon spanner and turn the 1/4 turns of screw on the right side clockwise.
If the running belt is still not in the middle, repeat the above actions until it is adjusted to the middle.
After adjusting the running belt to the middle, adjust the speed to 12KM/H and observe the deviation of
running belt and slippery condition of running.
If there is any deviation, repeat the adjustment steps.
PLEASE DO NOT TIGHTEN THE ROTARY DRUM TOO MUCH! THIS WILL
8.-

LUBRICATING OIL

The running machine was lubricated when it left the factory. But the lubricating property of the running
machine is often tested, which helps to keep the treadmill at its best use. A running machinemust be
lubricated after one year or 100 hours of operation.
Every 30 hours or 30 days after use, pull up the running belt from side and stretch your hand to touch the
surface of the running belt inward as far as possible, if you touch the silica gel oil, you do not need to
lubricate; if there is a strong sense of dryness when you touch the surface, please follow the instructions
below for refueling operation (please use non petroleum silica gel oil).
ENGLISH
11.
WARNING:
CAUSE PERMANENT BEARING DAMAGE.
，