Dimensions Of Screw-In Poppet Valve Sd1Ex-A3; Dimensions Of Screw-In Poppet Valve Sd1Ex-A2 - Argo-Hytos Rpex Gebrauchsanweisung

Dimensions of screw-in poppet valve SD1EX-A3

Dimensions in mm (in)
36 (1.42)
46 (1.81)

Dimensions of screw-in poppet valve SD1EX-A2

Dimensions in mm (in)
5+1 Nm
(3.7+0.7 lbf.ft)
36 (1.42)
46 (1.81)
CAUTION
The solenoid windings heat up during operation. Effective external cooling must be provided to ensure that the maximum winding temperature is not
exceeded, by not exceeding the maximum fluid and ambient temperature and by maintaining minimum volume of the connection block. A valve
body volume of (225cm ) is sufficient for one manifold. If several valves that can be switched simultaneously are connected on the connection plate,
3
a distance of at least 55mm must be maintained between the bodies of adjacent valves (see fig).
www.argo-hytos.com
Subject to change_SD1EX-A2(A3)_14088_1en_05/2022
4+0,5 Nm
(3.0+0.4 lbf.ft)
5+1 Nm
24
(3.7+0.7 lbf.ft)
30+2 Nm
(22.1+0.4 lbf.ft)
2
1
4+0,5 Nm
(3.0+0.4 lbf.ft)
24
30+2 Nm
(22.1+0.4 lbf.ft)
2 3
1
43 (1.69)
Correct installation of the valve
A missing or damaged ring after the thread will cause a leak of working fluid. Missing or damaged rings
on the valve body will cause internal volume loss and unreliable valve operation.
55 (2.17)
101 (3.98)
63 (2.48)
58 (2.28) 16 (0.63)
85 (3.35)
110,7 (4.36)
101 (3.98)
63 (2.48)
58 (2.28) 16 (0.63)
85 (3.35)
128 (5 .04)
55 (2.17)
Page 17