Pallmann 082728 Originalbetriebsanleitung Seite 32

9.2.2 Replacing the spare worn fasteners (Q)
1. Switch the machine off.
2. Unplug the mains plug.
3. Loosen the 6 screws (7 = TX20) of the steel disc
4. Pull away the worn fasteners and remove any adhesive residue using a
suitable thinning agent.
5. Affix any replacement fasteners, centring them to the cuts.
6. Reassemble the disc again in reverse order.
10. Disposal
Power tools do not belong with household waste. Please observe the national
legislation and recycle the packaging, accessories and tool accordingly.
11. Trouble-shooting
Fault Possible
Machine does not start
Excessive dust produced whilst
sanding
Sanding ineffective
Frequent replacement of the V-
belt necessary
High level of vibration
Seite 32 Gecko Star 2.0
cause Remedial
Power supply interrupted
Defective fuse
Cable or plug defective parts replaced
Brushes worn out or broken
Dust bag is not properly attached
Dust bag full
Sandpaper worn out
Speed dropping Retightening V-belt
Brushes worn out or broken
Belt pulley damaged
Machine wearing parts worn out
action
Have fault rectified by Electrician
Have an electrician rectify
User to check fastening of dust bag
Empty dust bag
Change the sandpape
Have fault rectified by electrician
Have fault rectified by electrician
Send machin for repair
12/2016