Intended Use - Pallmann 082728 Originalbetriebsanleitung

3.3 Safety devices
Restart protection
If the power supply is interrupted while the tool is running, e.g. by pulling out the mains plug, the
electronic restart protection function ensures that the GECKO STAR 2.0 does not start up by itself when
the plug is put back in.
Over-temperature shutdown
The over-temperature shutdown function protects the motor from overheating and resultant
damage. The machine switches off in the event of it reaching a critical temperature. The machine
can be restarted after a cooling down period of a few minutes.
Cut-off coal
The machine is equipped with turn-off charcoal. If the carbon brushes have reached their wear limit,
the machine switches off and can only be abused (manipulation at the switch). This will damage the
motor. Bring your machine to a suitable service center to replace the carbon brushes after being
switched off by the carbon brushes.
4.

Intended use

The parquet edge sander GECKO STAR 2.0 is suitable for the dry sanding of stairs
and landings as well as the dry sanding of the edges of parquet flooring and floorboards.
Other use is not permitted.
Caution!
Never carry out wet operations with the GECKO STAR 2.0.
(Fatal hazard from electrical shock)!
5. Safety
5.1 General information
The following safety instructions guard against injury and prevent improper use of the tool.
All users of this tool and persons involved in its assembly, maintenance or repair must have read
and understood the contents of this operating manual before beginning their work.
Particular attention should be paid to the sections featuring additional symbols.
5.2 Improper use
The GECKO STAR 2.0 is not suitable for brushing, polishing, or any similar purpose. Failure to adhere
to this directive can cause serious personal injury and damage to property.
5.3 Original parts and accessories
Original parts and accessories have been especially designed for the GECKO STAR 2.0. We would like
explicitly point out that other parts may not be used in their place. To do so can negatively impact
upon the safety of the tool.
This applies particularly to the tool's sanding disc. The manufacturer excludes all liability for damage
occurring through the use of non-original parts.
Seite 23 Gecko Star 2.0 12/2016