Pallmann 082728 Originalbetriebsanleitung Seite 28

6.5 Attachment and replacement of Velcro-backed abrasive discs (H)
Caution! Hazard due to running machine!
There is a risk due to unintended start-up of the GECKO STAR 2.0 machine when
replacing the sanding disc. Be sure to unplug the mains connector before replacing the
sanding disc.
Caution! Risk of cutting injuries to the hands!
The grinding grains on the sanding discs have sharp edges. Wear protective gloves when
changing the sanding discs.
Caution!
The sanding disc must lie centrally on the sanding plate. Ensure that there is an even
margin around the edge of the sanding disc.
Steps:
1. Switch the machine off.
2. Unplug the mains plug.
3. Lay the machine down on its side.
4 Take the used sanding disc (1) off the sanding plate (2).
5 Place a new Velcro-backed sanding disc centrally on the sanding plate
and press the sanding disc on.
Use following sanding discs: (I)
6.6 Attachment and replacement of abrasive discs that are fastened on with the
paper holding plate. (J)
Caution! Hazard due to running machine!
There is a risk due to unintended start-up of the GECKO STAR 2.0 machine when replacing
the sanding disc. Be sure to unplug the mains connector before replacing the sanding disc.
Caution! Risk of cutting injuries to the hands!
The grinding grains on the sanding discs have sharp edges. Wear protective gloves when
changing the sanding discs.
Steps:
1. Switch the machine off.
2. Unplug the mains plug.
3. Lay the machine down on its side.
4. Hold the sanding disc (3) firmly in place.
5. Unscrew the paper holding plate (2) with the two-pin spanner (1).
Remove the worn sanding disc.
6. Place the new sanding disc on and fasten this with the paper holding plate.
Tighten the paper holding plate down with the two-pin spanner (1).
Seite 28 Gecko Star 2.0 12/2016