Direct Mounting - Bodypoint Sh210 Bedienungsanleitung

PACKAGE CONTENTS
• Shoulder Harness
• Cinch-Mount™ or Flat-Mount™ End Fittings
• Cam Buckles (Optional –Art. No. FS032-2)
INSTALLATION
Seat user in wheelchair and establish correct posture with
Pelvic Support Belt: Place harness on user with upper
straps between neck and shoulder joint.Center the
sternum strap on the sternum.
LOWER STRAPS
Wrap lower straps around backrest without obstructing other
devices on wheelchair. Mount end fittings above top of the pelvis,
between middle and lower back height. Attach to backrest using
suitable fasteners.
DIRECT
MOUNTING
Rear-Pull versions
only. Attach Cam
Buckle to backrest
using suitable
fasteners. Thread
webbing through
buckle. Suitable for
users up to 75kg.
Cam Buckle
Cinch-Mount™ Flat-Mount™
INSTALLATION REQUIREMENTS
1. Wheelchair with a solid backrest or strap guides set
approximately at shoulder height (adjust up/down for
pressure distribution).
2. Mounting screws with a minimum pullout strength
of 200lbs/90kg. Not included in package.
1
2
3
TOP STRAPS
1. Adjust each shoulder strap for a comfortable fit,
according to the user's shoulder width and sitting posi-
tion. Mark for mounting screws to hold this position.
2. Attach to backrest using suitable fasteners.
FITTING
Position the user in wheelchair and fasten the
pelvic support belt securely, then buckle the
shoulder harness sternum strap, and adjust
sternum width Adjust the lower straps to prevent
the sternum strap from riding-up. Then tighten
the top straps to position the pads and to
properly support the user.
SAFETY CHECK
When properly positioned in wheelchair, have
user lean forward and side to side to check fit.
Check for:
1. Normal operation of buckles and adjustment
straps.
2. Comfort If rubbing neck, relocate upper straps.
3. Position If too high or too low adjust lower
straps.
4. Interference with other devices Relocate straps
as necessary to clear seat tilting mechanism,
armrests, accessory pads, or feeding tubes.
en
Ø5-6mm (3/16 - 1/4")