Device Menu; Maintenance Of The Device - Emos EM-10AHD Bedienungsanleitung

You can manually activate video recording or take pictures
during a call
Setting image zoom:
The setting can be changed by long-pressing the
and adjusting the value using the arrows.
Setting view height while the zoom feature is
active:
The setting can be changed by long-pressing the
and adjusting the value using the arrows.

Device Menu

– System settings
Set time, date, language, reset to factory settings
– Door unit
Set automatic recording, duration for video, relay connection,
motion detection
– External CCTV cameras
Set alarms, duration for video, alarm sensors and motion
detection on secondary CCTV cameras
– Ringtone setting
Timing, duration and volume of the ringtone, selection of
ringtone types. You can also set your own ringtone from
a memory card. The ringtone files must be stored on the
memory card in the Ring folder.

Maintenance of the Device

The device is low-maintenance. It is recommended, based on the condition of the device, to occasionally wipe the device
down with a moistened cloth.
Attention!
Before cleaning, the device must be disconnected from power!
FAQ
The device does not work
Check the cables and the connection of the power supply to the grid.
If you used an extension cable on the power supply cord, check that the polarity is correct. Measure the power supply with
a multimeter. The output voltage on the connector should be 12 V DC (+/- 1 V).
The image/sound is not clear, the device does not ring
Remove the monitor or the door camera unit and connect it using a short cable to eliminate the possibility of a interrupted
conductor in the house.
Then check the image and sound settings (brightness, contrast, colour, volume).
Enter the menu by pressing:
Speaker Volume Settings
Settings are changed by pressing
value using arrows while a video image is active
Setting image brightness:
icon The setting can be changed by long-pressing the
and adjusting the value using the arrows.
Setting image contrast:
The setting can be changed by long-pressing the
icon
and adjusting the value using the arrows.
Setting image colour temperature:
The setting can be changed by long-pressing the
and adjusting the value using the arrows.
– Play recordings
Play recordings and browse photos from door units and
CCTV cameras. A memory card must be inserted for this
feature to function!
– Memory card
Browse files stored on the memory card
– Digital picture frame
Setting for the LCD in standby mode. Allows displaying a
clock, or showing pictures from a memory card. The files
must be stored on the memory card in the DigitalFrame
folder.
– Mode setting
Selection of modes – at home, do not disturb, not at home
Settings for image signals
6
and adjusting the
icon
icon
icon