Werbung
Verfügbare Sprachen
Verfügbare Sprachen
4
5
9
English
Adjust the camera's viewing
angle as needed.
Attach the dome cover to the
camera base by tightening the
screws.
Troubleshooting
Camera is not Powering on
If your camera is not powering on, please try the following solutions:
• Make sure your camera is powered on properly. The PoE camera
should be powered by a PoE switch/injector, a Reolink NVR or a 12V
power adapter.
• If the camera is connected to a PoE device as listed above, connect
it to another PoE port and check again.
• Try again with another Ethernet cable.
Picture is not Clear
If the picture from the camera is not clear, please try the following
solutions:
• Check the camera dome cover for dirt, dust or spiderwebs, and clean
the dome cover with a soft, clean cloth. The dust-absorber included in the
package is recommended.
• Point the camera to a well-lit area, the lighting condition will affect the
picture quality a lot.
• Upgrade the firmware of your camera to the latest version.
• Restore the camera to factory settings and check out again.
English
10
Werbung
