Caring - Rotel ICECUBEMAKER9904CH Gebrauchsanweisung

STEP 7
o Press the ICE button to switch off the appliance.
STEP 8
o Place a container under the appliance, remove the drain plug on the inside of the water
tank to drain the remaining water and then replace it.

• CARING

o Clean the inner liner, ice collecting tray, water box, ice shovel and evaporator frequen-
tly. When cleaning, unplug the unit and remove the ice cubes. Use a diluted solution
of water and vinegar to clean the inside and the outside surface of the ice maker. Do
not spray ice maker with chemicals or diluted agents such as acids, gasoline or oil.
Rinse thoroughly before starting.
o Keep ventilation openings in the appliance enclosure, or in the built-in structure, clear
of all obstructions. Do not use mechanical devices or other means to accelerate the
defrosting process, other than those recommended by the manufacturer.
o If the machine is reused after a long time, it may be that the water pump cannot pump
sufficient water due to the air inside, in this case the ADD WATER icon will light up. To
correct this press the ICE button again, then the machine will work normally.
o To ensure the cleanliness of the ice cubes, the water in the water reservoir should be
replaced every 24 hours.
o If the compressor stops for any reason such as water shortage, too much ice, power
off, etc... do not start the system right away, wait 3 minutes, and then re-start the ice
maker.
o Always change with fresh water before starting ice production at initial installation or
after long shut-off periods.
Gebrauchsanweisung ○ Mode d'emploi ○ Istruzioni per l'uso ○ Instruction for use
40