Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Batt M60
Batt M50
Fix Hours
(****) h
UID
UID:29AA04 ******
Def.Set
YES/NO
1)
RDM UID
This device supports RDM (Remote Device Management), which makes remote control of devices
connected to the DMX bus possible. ANSI E1.20-2006 by ESTA specifies the RDM standard as an extension
of the DMX512 protocol. RDM simplifies device configuration as manual settings like adjusting the DMX
starting address are no longer needed. RDM is integrated in DMX without influencing the connections. The
RDM data is transmitted via the standard XLR pins 1 and 2 – new DMX cables are not necessary. RDM-
ready and conventional DMX devices can be operated in one DMX line. The RDM protocol sends own
packages in the DMX512 data feed and does not influence conventional devices. DMX splitters, however,
must support RDM. Which parameters can be called up via RDM depends on the RDM controller used.
BattM60 – 60% LED power in battery mode
BattM50 – 50% LED power in battery mode
Operating hours
****.- displays the fixture hours. The display shows "****", "*" stands for
the number of hours.
1)
RDM UID
Reset to factory settings
32/40
00150750.DOCX, Version 1.0
Werbung
