Intenso PD10000 Bedienungsanleitung Seite 14

b) Charging devices with the Powerbank
This Powerbank has a USB-A port (USB-A OUT QC) and a USB-C port (USB-C In/Out PD), both of which can
be used to charge devices.
The USB-A port supports the Qualcomm Quick Charge (QC) 3.0 Standard (Output normal: 5V/3A max.; Out-
put QC: 5V/3A, 9V/2A, 12V/1.5A max. = max. 18 Watt).
The USB-C port supports the Power Delivery (PD) Standard (Output normal: 5V/3A max.; Output PD: 5V/3A,
9V/2.22A, 12V/1.67A max. = max. 20 Watt).
To charge your device with USB-C port, simply use the supplied USB-C to USB-C cable. Of course you can
also use your own USB charging cable to connect the Powerbank with your device. Please note, however,
that for the Quick Charge Technology and the Power Delivery standard cables are required, which support
this standard (if necessary ask the manufacturer of your USB cable).
To charge your device, simply connect the supplied cable with the USB-C port (USB-C In/ Out PD) of the
Powerbank and the other end with the USB-C port of the device to be charged. Alternatively, connect your
own cable - depending on cable type- with the USB-A port (USB-A OUT QC) or the USB-C port (USB-C In/
Out PD) of the Powerbank and the other end with the device to be charged. The charging process starts
automatically and the devices determine the suitable charging current independently. If the Power Delivery
Standard or the Quick Charge Technology are used, this is shown on the display by a green point above
the percent sign.
You can charge two devices simultaneously with the Powerbank. The Quick Charge Technology and the
Power Delivery Standard are, however, only supported when just one device is charged. When charging 2
devices simultaneously, the ports share the maximum output of 5V/3A = 15Watt.
If a device is charged with the Powerbank and the capacity of the Powerbank is almost exhausted, this is
signalled by blinking of the last number from 5% residual capacity. Please recharge the Powerbank soon.
Please note that while charging a device with a Powerbank, about 30% of the total capacity is used up just
through the charging process. This is due, for example, through the loss of power from circuit warmth and
voltage conversion.
The Powerbank has to be used regularly for optimum performance. If this is not the case, charge the Power-
bank fully at least every three months.
Make sure that the warmth created through the charging process can be emitted from the device (ideally
place the Powerbank on a firm and heat-resistant base while in use).
SERVICE / DISTRIBUTOR
INTENSO INTERNATIONAL GMBH I Kopernikusstraße 12-14 I D-49377 Vechta
Email (technical support):
Email (RMA number):
Internet:
Telephone (technical support):
support@intenso-international.de
rma@intenso-international.de
www.intenso.eu
+49 (0) 4441 – 999 111 (Mon. – Thur. 09:00 – 16:30;
Fri. 09:00 – 14:00)
EN - Page 5 of 6