Werbung
Verfügbare Sprachen
Verfügbare Sprachen
SPECIFICATIONS
Connection voltage:
220-240VAC
Frequency:
50/60Hz
Dimming technology:
Trailing edge and leading edge (R,L,C)
Dimmable LED lamps:
0-700W Trailing (R,C)
0-700W Leading (R,L)
Lamps with electronic transformers:
5-800W
Halogen and incandescent lamps:
5-800W
•
Suitable for both retrofit bulbs and new installations.
•
Two-wire connection - no neutral wire needed.
•
Soft start system for longer LED lamp life.
•
Overheat & overload protection.
Dimmer button
Niko adapter (art. ED-10072)
Only for Busch-Jaeger
Only for JUNG
Central plate
Cover frame
Niko adapter (art. ED-10072)
Only for Niko & Busch-Jaeger
Dimmer
SUITABLE BRANDS OF COVER MATERIAL
•
Berker by Hager
•
Busch-Jaeger
•
GIRA
•
JUNG
•
Kopp
•
Merten by Schneider
•
Niko*
•
PEHA
INSTALLATION
Step 1
Always ensure that the electricity is switched off during installation. Then connect the
power wires as shown in the 'Wiring diagram' .
Step 2
Now install the dimmer in the flush-mounting box.
Step 3
Now select the desired dimming technology (phase on (RL) or phase off (RC), more on
this under the heading "Setting leading or trailing edge".
Then switch on the electricity again. Switch on the connected lamps using the dimmer
shaft. Now set the MIN and the MAX as indicated under "Setting min. light level" &
"Setting max. light level".
Step 4
Replace the cover frame, central plate and dimmer button on the dimmer.
Step 5
In case a fuse breaks, you can easily replace it by using a small screwdriver to remove
the "Fuse box" from the dimmer and replace the broken fuse with the supplied spare
fuse. Simply snap the fuse out of the sleeve and then snap the new one back into place.
Then push the "Fuse box" back into the dimmer. The dimmer is ready for use.
Werbung
