Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Remote control batteries
The remote controller is powered by two dry batteries (2x R03/LR03, 3.0V).
1. Slide the battery cover on the remote control downward, to open the battery compartment.
2. Insert the batteries, pay attention to the (+) and (-) polarities of the batteries, check that they match with the
symbols inside the battery compartment.
3. Slide the battery cover back into place.
Do not mix old and new batteries or batteries of different types.
Do not leave the batteries in the remote control if it is not going to be used within 2 months.
Do not dispose of batteries as unsorted waste. Refer to your local laws for proper disposal of batteries.
Automatic restart
In case of an unexpected power cut, the product will restart and will continue in last used mode.
Air flow
Air flow can be adjusted manually with the louvers. Horizontally and vertically. Keep objects and obstructions away
from the air outlets. Keep the louvers fully opened.
Water drain
This product has 2 drains. The upper drain is for dry mode to use as a continuous drain. The lower drain is for
cooling mode.
1. Water drain with plug. 2. Drain hose.
To use dry mode (dehumidifying), remove the drain plug (1). Connect the drain hose (2) to the water drain. Place
the other end of the hose directly on a floor drain. For example, a floor drain in your basement floor.
Make sure the hose connection is fastened securely to avoid water leakage.
Ensure that the hose is not bent with any kinks that would stop the water flow. The end of the hose should be
directed down to let the water flow smoothly. When the drain hose is not used, install the drain plug firmly to prevent
water leakage.
1. Drain plug (lower). 2. Drain hose.
When you are using cooling mode, the water will gather in the lower drain.
When the water level of the lower drain reaches a predetermined level, the device makes a sound 8 times, the dis-
45
Werbung
