In Addition, You Will Require - Hanseatic Tc925B2F-Sdee Gebrauchsanleitung

Installation materials
(12)
No. Name
(12) Anti-tip feature
(13) Screws
(14) Cover

In addition, you will require:

– the drill template which is supplied
– A pencil and ruler/tape measure
– Rechargeable drill or similar with 3 mm
wood drill
– Phillips screwdriver
Installing the appliance
1. Place the drill template exactly in the cen-
tre of the installation alcove.
The marked contact edge must be flush
with the front floor edge of the installation
alcove.
=
2. Copy the drill hole marks onto the floor of
the installation alcove.
(13)
(14)
Quantity
1
3. Screw the anti-tip feature (12) tight with two
3
1
4. Slide the appliance into the installation al-
5. Connect the mains plug to the socket.
6. Slide the appliance fully into the installa-
7. Check that the appliance is positioned
=
8. Open the cooking chamber door (7), in-
Start-up
Drill to a maximum depth of 10 mm
to avoid drilling through the floor.
Ø 3
of the supplied screws (13).
cove slightly.
A beep will sound and
pear on the display (2) when you
connect the appliance to the power
supply.
tion alcove.
right in the centre of the installation al-
cove: the gap at the left and right side
must be of equal width.
cluding with the cooking chamber door
emergency opener if necessary (10).
Page EN-37
(13)
(12)
will ap-
0: 0 0