Comfy Go Mobility X-1 Bedienungsanleitung Seite 13

English
Assemble and Dissemble the Footrest
Install the footrest into the frame tube and push the footrest into the
fixed position. To disassemble, lift the footrest puller then turn the
footrest outwards then lift the footrest (Picture 5 and 6)
When adjusting the length of the footrest, the user should sit in the
wheelchair with their feet on the foot plates to determine if an adjust-
ment is needed. To adjust the footrest, loosen the bolt on the frame
near the support assembly. Raise or lower the foot plate to the desired
position that will provide maximum support to your legs. Front rigging
should not be so low that it causes an uncomfortable pressure to your
thigh area. The footrest should not be lower than 2 1 ⁄ 2" from the
ground to ensure proper clearance.
Parking brake
Push the brake handle forward to lock the wheels into place. Pull the
brake handle back to disengage the brakes. (Picture 7)
3. Usage and Operation
Picture 5
Picture 7
Picture 6
The parking brake is intended for use
when parking your wheelchair for long
periods of time. It is not recommended
to use the brake while in motion or as a
turning device. Both brakes need to be
engaged at the same time. Be certain
that the wheelchair is on a flat surface
before releasing the brakes. When
releasing the brakes, immediately place
both hands on each hand rim to ensure
control of the wheelchair.
12
English