Troubleshooting Guide - X4-Life 701085 Bedienungsanleitung

RGB LED Strip
4 All colors
Enable flash
function
Enable strobe
function
5
Enable fade function
Enable smooth
function

Troubleshooting guide

Fault
description
RGB LED Strip is not connected
to the mains
RGB LED Strip is not switched
on
RGB LED Strip
does not light
Plug in cable is not properly con
up
nected
Connector plug on RGB LED
Strip is incorrectly fitted into
connector socket of control unit
26
Press this button to cycle through all colors.
Press this button to enable the flash function.
Red, green and blue will light up alternately and
together.
Press this button to enable the strobe function.
Red, green and blue will blink simultaneously.
Press this button to enable the fade function.
Red, green and blue will light up alternately and
together with increasing and decreasing intensity.
Press this button to enable the smooth function.
Sequential light with all colors.
Cause Remedy
Check that the plug has been
inserted in the socket.
Check that the RGB LED Strip
has been switched on using the
remote control.
Check that everything is con-
nected properly.
Check that the arrows on the
male and female connectors
(plug and socket) are opposite
each other.