Werbung
Verfügbare Sprachen
Verfügbare Sprachen
rear racK BatterY 16 ah
16 ah Battery charger
• The supplied battery charger is suitable for the voltage 110-240V.
• Output: 29V ÷ 2A
charging process
• Plug the charger into an electrical socket. The green LED lights turn on showing the
electrical connection
• Connect the battery charger to the battery with the round magnetic plug. The battery
can be recharged both if removed or installed on the bicycle, in the latter case the
system must be switched off.
• When the battery is connected to the power, LED turns RED, charging is in progress.
If, after a few seconds it does not become red but remains green, you must press the
button on the battery backside and hold it for more than 3 seconds.
WarninG: after 7 days of inactivity, the battery goes automatically into stand-by
mode. to turn it on, hold the backside button at least for 3 seconds.
• When fully charged, the LED on the charger will turn to GREEN. The battery is fully
charged and the charging process is completed.
• Unplug the charger from the power supply.
• The time required for a full battery charge, change according to the model of the
battery and charging status. When the battery is completely discharged, it could takes
8÷9 h for a full charge.
• Do not allow the battery to charge end, remains for a long time connected to the
charger and power supply
range
• The battery mileage depends on various factors such as, for example:
- support of the assist unit set on the control panel (E –N -T)
- Type and difficulty of the path
- Weight of the rider and the bike
- Speed
- Ambient temperature and wind on the way
- Tires model and tyre pressure
• Braking-Sunstar recommended to choose the mode of support according to their
needs reminding that less effort corresponds to an higher consumption and so a
reduced battery mileage. The S03+ KIT supports the rider in proportion to its capacity
and reach automatically the best efficacy.
36
S03+ KIT
User manual
Battery StatUS
6. SYStem manaGement
1
2
3
4
5
Start the system
• only for 9ah battery - Verify that the battery button is on ON position.
• Press ON button on the control panel. The system start and motor control unit check
www.sunstaribike.com
nUMBer of leD
100% - 60%
3 led
60% - 30%
2 led
30% - 10%
1 led
10% - 0%
1 led blinking
0%
1 led slow blinking
M Button: Select assisting mode
LED E, N, T: Selected assisting mode.
LED for charge status
ON button
OFF button
only for 16ah batteries: if the battery is stocked more than 7days, it goes into Energy
safety mode; in order to reactivate the battery it's needed to press rear reset button for
more than 3 seconds.
the entire system functionality.
WarninG
When the system is running self-control process you should not
pedaling. if you accidentally ride during the self-check, system
may not work properly. in this case, turn the system off and turn on
again. at the end of self-control, the user can start pedaling.
S03+ KIT
User manual
WarininG: under
certain conditions with
a charge less than 10%,
the system may not work
properly / continuously.
1
2
3
4
5
37
Werbung
