Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Saddle BatterY 2,5 ah
Battery charger 2.5 ah
• The supplied battery charger is suitable for the voltage 110-240V.
• Output: 29V ÷ 1.75A
charging process
• Plug the charger into an electrical socket. Green LED lights turn on showing the
electrical connection.
• Connect the battery charger to the battery with the square plug. The battery can be
recharged both if removed or installed on the bicycle, in the latter case the system
must be switched off.
See table to verify the situations of the leD:
charGer leD liGhtS
StatUS
green
Charging process
green blinking
green
Complete charge. Now you can disconnect battery from
charger.
green
none
Power supply missing
none
green
Power supply available but battery not connected.
none
Temperature errore. Possible that battery temperature is too high
or too low.
The charging process will not start and the unit will enter in
green
stand-by mode.
orange
As soon as conditions return to normal, charging will resume
automatically (it is recommended to start charging when the
temperature became normal).
green
The charger or the battery have a problem.
Stop charging immediately and contact your dealer.
orange blinking
34
S03+ KIT
User manual
• When charging, the battery can heat up; this does not indicate a system malfunction
• The time required for a full battery charge, change according to the model of the battery
and charging status. When the battery is completely discharged, it could takes 2 or 3
hours for a full charge
• Do not allow the battery to charge end, remains for a long time connected to the charger
and power supply.
central doWntuBe and rear racK BatterY 9 ah / 11 ah
9 ah / 11 ah Battery charger
• The supplied battery charger is suitable for the voltage 110-240V.
• Output: 29V ÷ 2A
charging process
Connect the battery charger to the battery with the square plug. The battery can be
recharged both if removed or installed on the bicycle, in the latter case the system must
be switched off.
See Table to verify the situations of the LED.
• Plug the charger into an electrical socket. The green LED lights turn on showing the
• Connect the battery charger to the battery with the round plug. The battery can be
• When the battery is connected to the power LED turns RED, charging is in progress.
• When fully charged, the LED on the charger will turn to GREEN. The battery is fully
• Unplug the charger from the power supply.
• The time required for a full battery charge, change according to the model of the
• Do not allow the battery to charge end, remains for a long time connected to the
www.sunstaribike.com
electrical connection.
recharged both if removed or installed on the bicycle, in the latter case the system
must be switched off.
charged and the charging process is completed.
battery and charging status. When the battery is completely discharged, it could takes
4÷5 h for a full charge.
charger and power supply.
S03+ KIT
User manual
35
Werbung
