KERR ultra-waxer 2 Bedienungsanleitung Seite 4

5. Spatula / Tip Operation
Removing a Tip
Retract the spring loaded Quick Connect Collar (Blue)
towards the cord end of the Ultra-Spatula handle. The
movement of the collar will be about 0.3 cm. Gently
remove the Heating Tip in the opposite direction.
CAUTION Handle a hot tip with care to prevent burns.
Replacing a Tip
Retract the Quick Connect Collar (Blue) and insert the
Heating Tip about half way. Gently rotate the Heating Tip
until you locate the connection (two flat sides) that will
allow the Heating Tip to be inserted the rest of the way.
Use the Quick Heat feature (under Menu) once you have
changed to a new tip, the Quick Heat feature will bring the
cold Tip to a working temperature quickly.
Ultra-Waxer Heating Tips
1 2 3 4
1. 35167 Small PKT, Blue
2. 35168 Large PKT, Teal
3. 35169 Beavertail, Purple
4. 35170 Small #7, Grey
5. 35171 Large #7, Green
6. 35172 Needle, Red
7. 35173 ½ Hollenback, Black
8. 35174 Small Denture, Pink
9. 35175 Large Denture, Orange
10. 35176 Denture Spoon, Yellow
35177 Ultra-Spatula Cord/Handle
5 6 7 8 9
6. Application
Crown & Bridge Applications
Inlays, onlays, full crowns,
ceramic frameworks.
Assemble multiple unit
bridges, attach sprues.
CAUTION
1. Read complete Directions for Use before operation.
2. Confirm unit is connected to a grounded power source.
3. Keep unit away from water and moisture.
4. Do not touch heated tips when in use.
5. Intended for use with traditional waxes only.
6. Avoid allowing the heated tips to touch spatula wire.
7. Do not block the ventilation opening in rear of unit.
8. Keep heated tips in holder to avoid damage or injury.
9. Do not attempt to repair or disassemble the unit.
10. Contact Kerr Corp. for repair and/or troubleshooting.
HOT SURFACES
and internal exposed parts of the unit.
ALTERNATING CURRENT
current that reverses its direction at regularly
recurring intervals.
LIMITED WARRANTY
10
LIMITATION OF KERR'S LIABILITY
Kerr's technical advice, whether verbal or in writing, is
designed to assist dentists and laboratories in using Kerr's
product. The dentist or laboratory assumes all risk and
liability for damages arising out of the improper use of Kerr's
product. In the event of a defect in material or workmanship,
Kerr's liability is limited, at Kerr's option, to replacement of
the defective product or part thereof, or reimbursement
of the actual cost of the defective product. In order to take
advantage of this limited warranty, the defective product
must be returned to Kerr. In no event shall Kerr be liable for
any indirect, incidental, or consequential damages.
EXCEPT AS EXPRESSLY PROVIDED ABOVE, THERE ARE NO
WARRANTIES, BY KERR, EXPRESS OR IMPLIED, INCLUDING
WARRANTIES WITH RESPECT TO DESCRIPTION, QUALITY, OR
FITNESS FOR A PARTICULAR PURPOSE.
Fill undercuts, cover
sharp edges.
Seal margins of copings,
crowns, inlays and onlays.
- Do not touch external
- An electric