Werbung
Verfügbare Sprachen
Verfügbare Sprachen
2.4.4
Fasten the control unit by means of the 4 screws supplied (see drawing 6 ).
15
2.5 Electrical connections
2.5.1
Connect the grey cable from the external unit to its terminals on the internal con-
trol box (see drawing 7).
2.5.2
Connect the black coaxial cable from the satellite dish LNB to the F connector of
the control box.
Note: in satellite dishes with dual output, the second black coaxial cable from the satellite
dish must be directly connected to the second receiver (see drawing 7.1).
2.5.3
Insert the power connector supplied with the system into the special connector
on the control box.
2.5.4
Connect the black cable of the power connector to the negative pole of the do-
mestic battery and the red cable to the positive pole of the domestic battery.
2.5.5
Connect the green cable of the power connector to the special D+ position on
the vehicle dashboard. This enables automatic closing of the satellite dish in case it is left
in the up position.
10
6
Werbung
