Werbung
Verfügbare Sprachen
Verfügbare Sprachen
1. Press SET until the display shows [SEt dAtE] and press CAL.
2. The display shows [dAtE=on] or [dAtE=OFF]. Select the desired mode and press
CAL.
3. Program the date (respectively year, month and day) by pressing CAL each
time.
1. Press SET until the display shows [SEt tiME] and press CAL.
2. The display shows [tiME=on] or [tiME=OFF]. Select the desired mode and press
CAL.
3. Program the time (respectively hour, minutes and seconds) by pressing CAL
each time.
1. Press SET until the display shows [SEt °C] and press CAL.
2. The display will show the measured temperature e.g. [°C=23.7][Aut]. If neces-
sary, calibrate your probe and press CAL. Press RES to reset the temperature
calibration to the original factory calibration.
3. When no Pt1000 temperature probe is connected to the instrument the display
will show the manual temperature e.g. [°C=23.7][MAn]. Shift to the proper
temperature and press CAL.
1. Press SET until the display shows [SEt rEC] and press CAL.
2. The display shows for all channels e.g. [rEc=PH], [rEc=MV], [rEc=EC],
[rEc=°C]...etc. Select the desired mode and press CAL.
3. This step is skipped unless [rEc=EC] has been chosen. Press CAL and the display
shows the conductivity measuring range and units, e.g. [rEc 0.01MS][Unit].
Select the desired range and press CAL.
4. The display shows e.g. [rEc=6.00][LoW]. Select the desired minimum level cor-
responding to a 0 V recorder output and press CAL.
5. The display shows e.g. [rEc=8.00][HiGH]. Select the desired maximum level
corresponding to a 2 V recorder output and press CAL.
1. Press SET until the display shows [SEt CHAn] and press CAL.
2. The display shows e.g. [PH=on] or [PH=OFF]...etc. Select the desired mode
(respectively pH, mV and EC) by pressing CAL each time.
3. The display shows e.g. [rEF=25°C]. Select the temperature to which all future
conductivity measurements will be referred and press CAL.
R735 èwww.consort.be
Date
Time
Temperature
Recorder
Channels
5
Werbung
