Werbung
Verfügbare Sprachen
Verfügbare Sprachen
This instrument is manufactured with the latest technology and needs no particu-
lar maintenance. Consort certifies that this instrument was thoroughly inspected
and tested at the factory prior to shipment and found to meet all requirements
defined by contract under which it is furnished. However, dimensions and other
physical characteristics may differ.
The normal operating temperature should be between 0° and 40°C. Never use
the instrument in a room with high humidity (>95 %) or at very low temperatures
(condensation water!).
Connect the instrument only to an earthed power line. The required power source
is indicated on the label at the back of the instrument. Do not cut and splice the
power cord. When removing the power cord from the wall outlet, be sure to unplug
by holding the plug attachment and not by pulling the cord. Do not hold the plug
by wet hand.
Consort nv
Parklaan 36
B2300 Turnhout
Belgium
This instrument (excluding all accessories) is warranted against defective material
and workmanship for a period of thirty-six (36) months from the date of shipment
ex factory. Consort will repair all defective equipment returned to it during the
warranty period without charge, provided the equipment has been used under
normal laboratory conditions and in accordance with the operating limitations and
maintenance procedures in this instruction manual and when not having been
subject to accident, alteration, misuse or abuse. A return authorisation must be
obtained from Consort before returning any product for warranty repair on a
freight prepaid basis!
Consort is not liable for consequential damages arising out of the use or handling
of its products.
In the event of this instrument being returned for servicing, the owner is requested
to remove the power supply lead and NOT to send the following items unless they
are suspect:
Manual
Cables
Accessories
If serious malfunctioning occurs, stop using the unit immediately and consult your
local Consort dealer.
MODE
= Selects all modes or escapes from error traps, calibration procedures,
etc..by returning to the original mode.
CAL
= Starts or proceeds a calibration or a function.
Ù/Ú
= Button for entering a value or for selecting a function.
SET
= Installs the meter according your application.
HOLD
= Holds display when measuring.
RES
= Changes resolution/units of the display.
PRINT
= Displayed value is printed through the RS232 output.
ON/OFF = Switches the instrument on or off.
R735 èwww.consort.be
Tel (+32)(14)41 12 79
Fax (+32)(14)42 91 79
E-mail: info@Consort.be
Introduction
Manufacturer
Warranty
Servicing
Keyboard
3
Werbung
