Party Light & Sound PLUTON Bedienungsanleitung Seite 3

PREVIOUS/NEXT BUTTON
During play, press the PREVIOUS/NEXT button to go back to a previous or forwards to the next songs.
PLAY/PAUSE & TWS BUTTON
Press to stop playing the current track. Press again to resume play.
MODE/LED BUTTON
Long press to turn the light on/off.
Short press to select an input source among Bluetooth, FM, LINE, USB, TF
FM MODE
Short press the MODE/LED button and select FM mode. In FM mode, keep the PLAY/PAUSE&TWS button pressed
to search and save automatically all found radio stations. With the PREVIOUS/NEXT buttons you can select a
previous or next radio station.
BLUETOOTH MODE
Short press the MODE/LED button until BT is displayed. Activate the Bluetooth function on your Bluetooth en-
abled device and select PLUTON. Press the PREVIOUS/NEXT button on the top panel to select a song.
AUX IN JACK
Connect an audio cable to the AUX IN jack of the speaker and to the audio output socket on the external audio
device such as MP3 player, discman, etc. Press the MODE/LED button and select LINE.
MIC IN JACK
Plug in the supplied microphone.
USB INPUT
Insert a USB stick and start playing.
TWS WIRELESS BLUETOOTH CONNECTION
First pair your smartphone with a PLUTON speaker (cf. BLUETOOTH MODE). Turn on the second PLUTON and
press the PLAY/PAUSE&TWS button on the second PLUTON. The second PLUTON will now play the same music as
the first one.
REMOTE CONTROL
1. ON/OFF button
2. Play/Pause
3. EQ sound effect button
4. Number buttons to select the desired song/radio station
5. MODE button: press to select among Bluetooth, FM, AUX, USB, TF (microSD)
6. Mute
7. Previous
8. Next
9. Volume +/-
10. Single repetition (for USB/TF only)
11. USB/TF selection button
IR REMOTE CONTROL
Please operate the remote control within a 6m and 30° between the remote and
the appliance. Aim the remote at the sensor. Remove all obstacles between the remote and the sensor.
The remote control might not work properly if the sensor is exposed to strong sunshine.
If the remote control doesn't work properly, please check the batteries.
INSTALLING THE BATTERIES IN THE REMOTE CONTROL
• Place the remote face down on a flat surface.
• Push the compartment cover into the direction of the arrow.
• Slide the battery compartment open.
• Remove the old battery and install the new one (CR2032) with the plus (+) symbol facing up.
• Gently slide the battery compartment closed. It locks automatically.
RECOMMENDATIONS FOR BATTERIES
This symbol indicates that used batteries should not be disposed of with household waste but deposited in separate col-
lection points for recycling.
ATTENTION: Danger of explosion if battery is incorrectly placed. Only replace by the same or equivalent type.
Keep new and old batteries out of the reach of children.
©Copyright LOTRONIC 2023
1
Mode
2
3
EQ VOL- VOL+
SCN
0
RPT U/SD
1 2 3
4
4 5 6
7 8 9
5
6
7
8
9
10
11
3