DeLOCK 42022 Bedienungsanleitung Seite 3

English
Hardware Installation
1.
Open the housing.
2. To do this, press the button on the bottom.
3. Now you plug your M.2 SSD into the slot.
4.
Fix the module with the help of the rubber nipple.
5.
RAID setting
Note: If you use a new hard drive, please make sure that it is
already formatted.
Use the DIP switch to set the suitable RAID mode.
6.
Close the enclosure.
7.
Now you can connect the enclosure via the USB interface to
your system.
8. Connect the power supply to the DC female port.
9.
Switch on your computer.
10. Press and hold the reset button and short press the on / off
button.
11. Then the corresponding RAID LED lights up, as well as the
Power LED.
12. After detecting the SSD, the corresponding LED of the SSD will
light up.
13. Then the new drive must be initialized.
Select "MBR" for SSDs smaller than 2 TB and "GPT" for SSDs
larger than 2 TB.
14. A new volume must be created in the Disk Management.
15. The external drive will be recognized and you can start using
the device immediately.
-3-